PASTA Lite KYZ remix 3D printed using ASA filament with a 50% gyroid infill on my Creality K2 Plus. Works amazingly well on respooling filament. Original spool was warped and had issues functioning in my CFS unit. Used the 608 bearings upgrade variation and the 3/8″ drive modification. Flawless respooling with zero effort!
ZILLATRONIX YouTube channel: Gaming, Tech, & Media – https://www.youtube.com/@zillatronix
D3RPZILLA YouTube channel: Automotive, Garage Mods, & More – https://www.youtube.com/@d3rpzilla
Item(s) in Video:
* PASTA lite Receiver – a Pastamatic Remix – https://makerworld.com/en/models/930059-pasta-lite-receiver-a-pastamatic-remix
* PASTA lite Donor Spinner – https://makerworld.com/en/models/940440-pasta-lite-donor-spinner
* PASTA lite 3/8″ Drive – https://makerworld.com/en/models/1046922-pasta-lite-3-8-drive
* Bearings 608zz – https://amzn.to/4saMfPL
* FLASHFORGE ASA Filament 1.75mm Sparkle White – https://amzn.to/4w1osDi
* Reusable Filament Spool – https://amzn.to/47uTkm4 (not used this time, but a good option if you do not have any good left over filament spools)
Merch Shops:
ETSY STORE – etsy.z1lla.com
— ETSY STORE 25% Off Promo Code – D3RPZILLA25
Z1LLA SHOP – shop.z1lla.com
— Z1LLA SHOP 25% Off Promo Code – D3RPZILLA25
#3dprinting #3dprints #3dprinted #filament #k2plus #respool #creality
Music:
➤ Music from Epidemic Sound
Get vidIQ to grow your channel faster! 🚀
https://vidiq.com/D3RPZILLA
NOTE: This video may contain affiliate links & could make a small commission from purchases utilizing these links at no extra cost to you.
Add comment